Skip to content
Charcoal Ten
Ask an advisor
Concept render of the C10, studio lighting
Concept render
The truck

What is
on it

Read this first. The truck is not finished. The renders on this page show where it is going. The shop photographs show where it is. Every image is labelled and we do not present one as the other.

Specification

Year / model1967–72 Chevrolet C10, short bed
RearWidebody tubs, hand-formed
StanceSlammed, wheels inside the fender line
InductionHolley EFI, 105mm throttle body
Valve coversFabricated polished aluminium
BlockOrange, cast finish
ChassisTubular front end, coilovers
LightingHalo projector headlights
InteriorRoll cage, black race seats
WheelsBlack, deep dish rear
FinishSatin charcoal
GrilleBlacked multi-slat
Parts

Grouped by system

Links go to the retailer. Some of them pay us a commission. It does not change what went on the truck, and anything fabricated in-house is marked as such because you cannot buy it.

Engine and EFI
Holley EFI
105mm throttle body and intake. Chosen for the tuning support, not the badge.
Fabricated valve covers
Polished aluminium, made in-house. Not an off-the-shelf part.
Fabricated in-house
Serpentine drive
Single alternator, standard accessory layout.
Chassis and suspension
Tubular front end
Replaces the factory crossmember. Opens up the engine bay.
Coilovers
Front and rear. Ride height set for the wheel-in-fender look.
Wheels and tyres
Wheels
Black, deep dish at the rear to fill the tubs.
Tyres
Sized to the tub, not to the catalogue.
Body and finish
Widebody tubs
Hand-formed. No bolt-on kit.
Fabricated in-house
Satin charcoal finish
Satin, not matte. There is a difference and it shows in daylight.
Lighting
Halo headlights
Projector with the ring. The signature of the front end.
Interior
Roll cage
Bolted through the floor, tied to the chassis.
Race seats
Black, fixed back.
Parts list

Want the full list as a file?

Part numbers, sizes and sources in one PDF. $19 when it publishes, free to the list for the first week.